How to Replace Hoover React UH73301 Drive Belt (Step-by-Step Guide)

⏱ ~10 minutes 🔧 No tools needed 🔄 Difficulty: Easy

Replacing the Hoover React UH73301 drive belt is a straightforward DIY job that takes under 10 minutes and requires no special tools. Follow these steps and you'll restore full performance without paying a service fee.

📦 Need a replacement part first?

Compare all compatible Drive Belt options for your Hoover React UH73301 before starting: View Hoover React UH73301 Drive Belt options →

Step-by-Step Guide

1
Unplug the vacuum
Always disconnect power before any internal work on your Hoover React UH73301.
2
Open the base plate
Remove any screws securing the base plate and set aside.
3
Remove the brush roll
Lift out the brush roll to expose the belt underneath.
4
Remove the old belt
Slide the worn belt off the motor spindle and brush roll hub.
5
Install the new belt
Loop the new belt around the motor shaft first, then stretch over the brush roll hub.
6
Reassemble and test
Replace brush roll and base plate. Test that the brush roll spins freely.

⚠ Common Mistakes to Avoid

  • Never clean filters with water unless the manual explicitly says they're washable
  • Don't force the part — if resistance, check alignment before applying pressure
  • Confirm the replacement part matches your exact model number before purchasing
  • Always disconnect power before any internal work
🔁 How often?

The Hoover React UH73301 drive belt should be replaced Every 12 months under normal use. With pets or daily heavy use, consider replacing more frequently.